1971–1986: The Beginning … 2021 is a milestone year for Xuron Corporation as it marks our 50th year in business. Our story starts in Danbury, Connecticut in old dairy barn that was converted to a factory.
Read MoreRecently we’ve had a few questions from customers asking how to replace springs on their tools and how to keep them (tools) cleaned and well maintained. I thought I’d share……
Read MoreFive years ago I wrote a blog post about Xuron® Tools for 3D Printing. At that time, 3D printers were not readily accessible to the average consumer or small manufacturer. They were mainly used for making prototypes and everything about the process seemed intimidating (at least to me). Speed ahead to 2020 and 3D printing […]
Read MoreXuron Corporation’s legacy tool series, the Model 170-II Micro-Shear® Flush Cutters, have been used in industry for over 40 years. When first introduced, these cutters were used primarily for trimming component lead wires for through-hole printed circuit board manufacturing. Times and technology have changed since the days of through-hole PCBs but rather than facing shrinking […]
Read MoreAccording to The Institute for Supply Management, the US manufacturing sector is expanding at a very robust pace. This means factories are busy and paying close attention to productivity and options for enhancing output without increasing the risk of soft tissue injuries. Pneumatic wire cutters offer a cost effective and ergonomic solution.
Read MoreCopyright © 2019 Xuron Corporation · All Rights Reserved · Privacy Policy • Terms of Service • Disclaimer